Boring Bars
Carbide boring tool-bit sets with precision-ground ½", ¾" & ⅜" shanks.
This quick-change tool-bit holder also has a V-notch to hold a round (⅜") boring bar shank.
This quick-change tool-bit holder holds a ¾" shank boring bar.
A boring operation at 637 RPM & using a
fine feed. The cutting tip is at or above center.
A 2" diameter boring head with a MT-2
(screw-on) arbor can be used
in the lathe's tailstock.
A rigid setup with good control.
Boring bar set: ⅜", (2) ½" , ⅝", ¾" & 1"
diameter sizes.
⅜" holds 3/16" round tool bits; others hold various sized square bits.
Each bar holds bits either perpendicular or at a 45° angle.
Good for inside boring & inside threading. More
boring bars.